Cart 0
EarthQuaker Devices Levitation V2 Reverb Effects Pedal

Earthquaker Devices

EarthQuaker Devices Levitation V2 Reverb Effects Pedal

$ 189.00

The Levitation reverb, designed by EarthQuaker Devices, honors the spirit of the LEVITATION music festival.  Now, EarthQuaker presents Version 2 of the Levitation, featuring soft-touch relay-based switching for truly silent and effortless operation with increased long-term durability.

LEVITATION, founded as Austin Psych Fest in 2008, has become a way to honor and preserve Austin’s psychedelic rock heritage, and carry it into the future. Remaining true to the theme of LEVITATION, Earthquaker decided to create a variation on their popular Ghost Echo pedal to honor the reverb-drenched tones synonymous with classic psychedelic rock. The result is the Levitation Reverb pedal. This pedal builds on the base found in the Ghost Echo but does away with the attack and dwell while adding controls for tone, decay, atmosphere and length. It is a vintage voiced reverb that aims to fit somewhere between dirty sixties chambers, classic spring, and the big ringing plate reverbs of days gone by.

Four knobs and one switch control quite a bit more than you’d expect. Want a slap back small room sound? Set all of your controls to the minimum and use the mix to dial in the sound of room devoid of anything but a guitar and amp. Want to revel in infinite spatial oscillations? Flip the toggle to long, turn up the atmosphere and decay then tune out. Dial in a bright chiming slap back by turning the tone all the way counter clockwise and reducing the decay. For a rattling, full-bandwidth assault, dime everything and let ‘er rip.

Each Levitation Reverb is built entirely by hand in Akron, Ohio by EarthQuaker Devices.


Length (Toggle): Broad stroke control for decay time. Shorter to left, longer to the right.

Decay: Controls the length of the reverb decay. Longer clockwise, shorter counter clockwise.

Atmosphere: This is a harmonic regeneration control, it feeds the upper frequencies of the reverb trails back through to create a more harmonic (ringing) reverb. More atmosphere clockwise, less counter clockwise.

Mix: This controls how much wet signal is blended in with the dry. More reverb clockwise, less counter clockwise.

Tone: This is an input bandwidth control for the reverberated signal. All the way counter clockwise reduces all low end content to make a brighter reverb, turning counter clockwise allows more low end to pass through resulting in a fuller reverberated tone.

Input impedance: 1M

Output impedance: >1K

The Levitation V2 Reverb is True Bypass.


3.25" x 3.25" x 5.75"; Weight 13 ounces.


The Levitation V2 Reverb uses a standard 9 volt DC power supply with a 2.1mm negative center barrel. Earthquaker recommends pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. Do not run at higher voltages! Current draw is 50 mA.



  • Psychedelic vintage spring/plate-style reverb
  • Long and short reverb modes
  • Upgraded op-amps for better performance and lower noise*
  • Accutronics reverb tank
  • New artwork*
  • True-bypass
  • Silent soft-touch switching*
  • All-analog dry signal path
  • Built entirely by hand in psychedelic Akron, Ohio
  • Lifetime guarantee


CALIFORNIA PROPOSITION 65 WARNING. WARNING: This product can expose you to chemicals including Cobalt, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Share this Product

More from this collection